Biamp A4 User Manual Page 181

  • Download
  • Add to my manuals
  • Print
  • Page
    / 217
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 180
System Control
RS-232 Control
The RS-232 port on the back of an Nexia unit is set to a default baud rate of 38400, 8 data bits,
no parity, 1 stop bit, and no flow control. (38400:8:None:1). If multiple Nexias are connected
together in a system then only one RS-232 port needs to be connected to a third-party control
system; communication data is shared via Ethernet through a switch.
When controlling multiple Nexia units that are not part of the same NEX file, each Nexia unit will
need to be addressed via its own RS-232 port from a control system or PC. Nexia units cannot be
linked together via RS-232, like some other BIAMP products can.
(The RS-232 baud rate can be set to 9600, 19200, 38400, 57600, or 115200 – default is 38400)
A straight through PC Serial Cable is used to communicate from an RS-232 port on a third-party controller (or PC*) to the
RS-232 port located on the back of an Nexia unit.
Since the Nexia's serial port does not implement flow control, waiting for a response from the Nexia is essential prior to
sending the next command. After receiving the +OK response, the next command can be sent. By waiting for the +OK
response, the serial buffer will not be overloaded.
(* A PC can send/receive NTP Strings, using a terminal emulator program such as
HyperTerminal.)
Telnet Control
Nexia can be controlled using Telnet via TCP/IP. The same command strings that are used for
RS-232 Control are used for Telnet.
When controlling multiple Nexias that are not a part of the same NEX file, each Nexia device will
need to be addressed via its own Telnet session from a control system or PC.
Nexia supports standard Telnet Echo Negotiation. By default, the Telnet server will echo
characters sent to it, one by one.
167
Page view 180
1 2 ... 176 177 178 179 180 181 182 183 184 185 186 ... 216 217

Comments to this Manuals

No comments